Tripp-Lite U442-DOCK5D-GY Manual Del Propietário página 6

Installation
Note:
• When the USB-C port is connected to a power source,
15W of power is dedicated to the docking station and other
devices. The remainder is used to charge the connected
device.
• See Optional Accessories section for suggested cables.
• In the event the detachable USB cable is lost or misplaced,
a USB-C to USB-C 5A 3-ft. cable (such as Tripp Lite's U420-
003-5A, U420-003-G2-5A or U420-C03-G2-5A cables) can
be found at www.tripplite.com.
• When the unit is connected to the USB-C port on your
computer and to a network via Cat5e/6 cabling, a network
connection will be automatically established. If no connection
is made, you can manually establish one by going to your
computer's network settings. For example, when using a
Mac, you would navigate to the "Network" icon found in
System Preferences; click the "Assist Me" button to access
the Network Setup Assistant, then follow the prompts to
establish a connection.
1. Using the included USB Type-C Gen 2 5A cable,
connect the docking station's USB-C host port to
the USB-C or Thunderbolt 3 port on your laptop,
tablet or other device.
2. Using an HDMI cable (such as Tripp Lite P568-
Series High-Speed HDMI cables), connect the
dock's HDMI port to the HDMI port on a monitor.
3. Connect up to three USB devices to the dock's
USB-A hub ports for data or charging.
4. Connect a USB Type-C device to the dock's Type-C
port for data or charging.
6