Tokai TB-133PE Manual De Instrucciones página 19

The unit is designed to play normal music CD disc or MP3 disc bearing the correct identification logo.
If the disc does not conform to the standard, it may not be played back properly.
Caution:
 Playback of CD-R / CD-RW may depend on recording conditions.
 Do not attach a seal or label to either side (the recordable side or the labelled side) of a CD-
R/ RW disc. It may cause malfunction.
 Do not load a blank CD-R/ RW disc. It will take over 1 minute to read the disc. The disc may
be damaged if you try to open the CD Door while reading the disc.
 CD-ROM, CD-I, CDV, VCD, DVD or computer CDs are not possible to be read.
LOAD A DISC
1. Open the CD door by the Door open area.
2. Load a disc on the disc tray with the label side facing up.
3. Close the CD door.
PLAY A DISC (CD/MP3)
1. Press the POWER button to turn the unit ON (the standby indicator will be off).
2. Press the SOURCE button repeatedly to switch to CD mode.
3. Follow the steps above to load a disc.
4. The player begins reading disc immediately.
5. When the disc is successfully read, the total number of the tracks will be shown on the LCD display
and playback will start with the first track. (If a MP3 disc is inserted into the unit, the total number of
the albums will be shown in the LCD display first, and then the total number of tracks will be shown.)
6. Press the PLAY/PAUSE/CH+ button once to pause music playback, the elapsed time flashes on the
LCD display to indicate that the player is in Pause mode; press again same button to resume
playback.
7. Press the STOP/CH- button to stop music playback, the LCD display shows the total number of the
tracks again.
Remark:
 If there is no disc in the unit, "NO" will be indicated on the display.
 If the CD cannot be read, "NO" will be indicated on the display.
CD/MP3 PLAYER OPERATION
18