ASROCK Fatal1ty Z97M Killer Serie Manual De Instrucciones página 26

USB 2.0 Headers
(9-pin USB4_5)
(see p.1, No. 22)
(9-pin USB6_7)
(see p.1, No. 23)
USB 3.0 Header
(19-pin USB3_4_5)
(see p.1, No. 7)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 28)
1. High Deinition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect
them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
Chassis Speaker Header
(4-pin SPEAKER1)
(see p.11, No. 20)
22
USB_PWR
P-
P+
GND
DUMMY
1
GND
P+
P-
USB_PWR
Vbus Vbus
Vbus IntA_PB_SSRX-
IntA_PA_SSRX- IntA_PB_SSRX+
IntA_PA_SSRX+ GND
GND IntA_PB_SSTX-
IntA_PA_SSTX-
IntA_PB_SSTX+
IntA_PA_SSTX+
GND
IntA_PB_D-
GND
IntA_PA_D- IntA_PB_D+
IntA_PA_D+
Dummy
1
OUT_RET OUT2_L
J_SENSE
MIC_RET
OUT2_R
PRESENCE#
GN D
1
DUMMY SPEAKER
1
+5V DUMMY
Besides four USB 2.0 ports
on the I/O panel, there
are two headers on this
motherboard. Each USB
2.0 header can support
two ports.
Besides four USB 3.0
ports on the I/O panel,
there is one header on this
motherboard. Each USB
3.0 header can support
two ports.
his header is for
connecting audio devices
to the front audio panel.
MIC2_R
MIC2_L
Please connect the chassis
speaker to this header.