Fitting The Casing - Climit GG GMP Serie Manual Del Usuario

– replace the tie-rods in their origi-
nal position;
– replace the two lower front and
upper panels;
– install the smoke chamber and
the flange as in figure 6/a.
NOTE: before proceeding to con-
nect the system, test the boiler
block with a water pressure of 7.5
bar and fill in the "testing certifica-
te" completely.
Sonda termostato sicurezza Safety thermostat probe
8
7
2.6

FITTING THE CASING

The casing and the control panel
are supplied in separate cardboard
packages. The housing package also
contains the boiler documents and
the glass wool for insulating the cast
iron body. To fit the casing, proceed
as follows (fig. 8):
– insert the front crosspiece (4) into
the lower tie-rods;
– fix the left front side angle bar (2)
11
11
2
5
and the right front side angle bar
(3) to the tie-rods of the boiler
body, blocking them with the four
blind nuts provided;
– insulate the cast iron body with
the glass wool provided;
– fix the side parts (5) and (6) to the
angle bars using the ten self-tap-
ping screws provided, and secure
them at the back with the nuts
placed on the tie rods;
– assemble the lower rear panel (7)
10
1
6
12
3
4
1
9
Fig. 8
27