Operating Instructions - Kobalt SGY-AIR213 Manual Del Usuario

ASSEMBLY INSTRUCTIONS
10. Turn tool so that the cap screw is facing up (See Figure
10). Using the hex wrench, turn the cap screw clockwise
until accessory is properly secured.
OPERATING TOOL:
NOTE Before you operate the tool, make sure the proper
accessory is selected for the specific application. Always
make sure the accessory is properly secured before using,
and keep hands and other body parts away from any moving
parts of the tool.

OPERATING INSTRUCTIONS

1. Connect air supply hose to the male plug. Set the working
pressure at 90 PSI for best tool performance (See Figure 1).
NOTE Working pressure refers to the air line pressure set to
tool when tool is under working conditions.
2. Push lever (I) forward and press down on the trigger (C)
to start the tool (A) (See Figure 2).
Each surface application may require a different accessory.
Consult your local hardware store for further assistance if
needed.
NOTE Whenever using tool always use steady and even
pressure whenever making contact with any surface.
10
1
2
A
9
clockwise
I
C