Cleaning And Care - Team kalorik TKG SKV 1004 N Manual Del Usuario

Note:
1. During cleaning, foam may form in the water tank. The performance of the device is
not affected by slight foaming.
2. Detergent, soap powder, bleach and the like MUST NOT be added to the water tank.
3. Make sure that the vacuum cleaner is on a level, non-slip surface before releasing it,
to prevent it from falling over and causing possible damage to the unit or floor.
4. Turn off the vacuum cleaner before each shutdown, otherwise the rotating bristles
may permanently damage your (carpet) floor.
BATTERY WARNING
• Blue - Battery full
• Blinking blue - Less than 20% battery remaining
• Blinking red - Low battery status

CLEANING AND CARE

• Switch off the appliance before each cleaning.
• Wipe the housing of the hand vacuum cleaner and the main unit with a soft, dry cloth.
• Persistent stains can be removed with a damp cloth and some detergent. Dry the
cleaned area completely afterwards.
• Change the water in the tank while using the vacuum cleaner as soon as it is dirty and
after each use at the latest. To do this, press the release switch (11) and remove the
water tank (Ill. 10, Fig. 13). Proceed as for filling the water tank. Empty the water tank
and clean it thoroughly with water.
• Turn the inner tube (6) counterclockwise to remove it (Ill. 10, Fig. 15); you can also refer
to the marking. Clean the lid, tube, inner tube and textile filter with clean water and
let everything dry thoroughly before reassembling and installing the water tank.
• Lay the vacuum cleaner flat on the floor to disassemble the floor brush (6). To do this,
press the release switches (5a, 5b) simultaneously (Ill. 11, Fig. 16).
• Clean the dust container of the hand vacuum cleaner after each use. Remove the
dust container from the engine block by pressing the release button (2). We
recommend that you do this over a trash can (Ill. 9, Fig. 10).
• Remove the filter holder (6) and filter cartridge (7) by turning it counterclockwise (Ill. 9,
Fig. 11). Tap the filter cartridge and clean the filter holder under running water (Ill. 9,
Fig. 12). Allow all parts to dry before reassembling.
• Cleaning the filter and the dust container is very important, as it allows the device to
operate optimally and eliminates unpleasant odors.
• Manually rotate the mobile element of the floor brush regularly to remove any foreign
objects that may be stuck (Ill. 12).
•
• If the moving element does not rotate (Ill. 13), pull back the switch on the left side of
the brush (a) and remove the roller (b). (Ill. 13, Fig. 18). Remove dirt and grime. When
using a pair of scissors, be careful not to injure yourself or cut off the brushes (Ill. 13, Fig.
19 & 20). Put the roller back in and check if it can be easily moved manually (Ill. 13,
Fig. 21)
Note: After each use, check that the brush still rotates smoothly.
TKG SKV 1004 N 14