Fax +32 2 359 95 50
To clean flat damp surfaces, use the squeegee directly mounted on the dust compartment.
When vacuuming liquids, make sure the level of the liquid never exceeds the max level of the
dust compartment.
After having vacuumed liquids or humid particles, clean the dust collector to avoid smells. Then
dry the filter thoroughly if necessary (see "Cleaning and Maintenance" section).
The small brush can be mounted on the crevice tool and is useful to clean delicate surfaces or
tissues without scratching them.
IMPORTANT SAFEGUARDS
Never use the appliance to vacuum hot, glowing objects such as cigarettes, matches etc.
or sharp objects that could damage the filter.
Your vacuum cleaner can vacuum small amounts of liquid or humid particles but never
vacuum inflammable products.
Always use the squeegee when you vacuum liquids or wet particles.
When you decide to throw out your appliance, first remove the battery in order to protect
the environment. To do so, take the appliance off the bracket, and remove the plate
situated at the back of the appliance with a screwdriver to open the battery
compartment. Then cut the cables, remove the battery and dispose of the battery in an
environment-friendly way by putting it in a place specially conceived for this purpose. Do
not throw it in a regular dust bin.
Only use the appliance with the charger supplied.
To remove the battery, the appliance must absolutely be disconnected from the power
supply.
CLEANING AND MAINTENANCE
Cleaning the filter and the dust collector is extremely important as it allows the optimal use
of your appliance and eliminates the unpleasantness due to bad smells that can occur
after having vacuumed liquids or humid particles.
Remove the dust collector by pressing the release button situated on top of the appliance
(see picture C). We advise you to do this over a dust bin.
Remove the filter and its holder by pulling them towards you (see picture D).
Empty the dust compartment and clean it with soapy water if necessary.
To clean the filter you can detach it from its holder. To do so, unscrew both screws of the
filter holder and remove it (see picture E). You can then take the filter and clean it in
soapsuds if necessary. If you use soapsuds, rinse the filter with clear water and let it dry
before putting it back into the appliance.
Once the filter is clean and dry, put it back in its holder and screw back the filter holder as
before. Then reinsert the filter holder in the dust collector. To do so, make sure the ribs in
the dust compartment face the grooves situated on the edge of the filter holder (see
picture F). The correct position of the filter holder is extremely important, as it guarantees
the tightness between the dust compartment and the motor.
If the filter is too dirty or damaged, it must be replaced. To do so, please contact the
nearest customer service.
After having replaced the filter, attach the dust compartment to the motor unit.
REMOVING THE BATTERIES
The batteries must be taken out of the unit when the batteries no longer provide power
after charging or when you want to throw away the appliance.
Unplug the appliance, slide out the battery door from the bottom of the appliance and
remove the batteries. To do so, cut or break the wires that are soldered to the batteries in
order to eliminate only the batteries. Please dispose of your old batteries in an
environmentally friendly way.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
12
Assembly page 12/48
TKG KS 1000 - 121022