Troubleshooting Guide - Energetics POWER RUN 1750 Manual Del Usuario

Trouble Shooting Guide
SYMPTOM
Console display LED's do
not illuminate
Scrambled digitals on
LED display
Display shows E1
Display shows E3
Display shows E6
Display shows E7
CAUSE
1. No power to treadmill
2. Console wire is not connected or
improperly connected.
3. Overload, protecting started
Damaged monitor
1. RPM sensor problem
2. Console senor wire did not
connect to controller or improper
connection
3. Motor wire not connected or
motor damaged
4. Controller problem
5. Monitor problem
6. Magnet of roller problem
Over speed
1. Incline motor wire did not connect
Properly
2. Incline PCB problem
The VR inside incline motor did not
connect properly.
Check the wire connector.
Turn on-off power switch again.
f still not illuminated, then
service is required.
Service required
Check if all wires are properly
connected.
Turn on-off power switch again.
If still not illuminated, then
service is required.
Service required
Service required
Service required
8
SOLUTION