Front Operating Elements - Medion Akoya P56005 Manual De Instrucciones

Front Operating elements

Ref. Button

1
 
 

2
 + 

2
+

Operational display

*DDC = Display Data Channel: communication interface between display and pc. This allows the operating system
to automatically install and configure the display driver.
(Ill.: Front operating elements)
Description
You will start the OSD (On Screen Display) with this button. Press this button
again if you wish to leave the OSD.

1
+ Power block, when the OSD is not activated

1
+ OSD block, when the OSD is not activated
Hold the key combination until the bar siplayed has moved from left to right
completely, to activate/de-activate the block. A corresponding message will
appear on the screen.
Select a parameter and reduce its value with this button, when the OSD is
switched on.
If you are not in the OSD: direct call-up of the Contrast/Brightness menu.
Select a parameter and increase its value with this button, when the OSD is
switched on.
Confirm the selection of the parameter to be changed with this button.
If you are not in the OSD: choose VGA, DVI or HDMI as signal source.
DDC*/CI ON/Off (ON:DDC/CI ; Off:DDC/2B), when OSD is not active
Shows the operational state. Please also refer to page 14.
You can switch the TFT monitor on or to the Standby mode with this button.
Front Operating elements
DE
EN
FR
ES
IT
NL
DK
11