Mounting The Pump On The Base Plate - Steinbach Classic 250N Active Balls+ Manual Original

13. Place the locking ring
head and filter vessel connecting point.
8
14.
Insert the screws of the locking ring and tighten them clockwise.
15. Remove the bleeder screw
head by turning it counter-clockwise.
16. Wrap the manometer thread
Teflon tape
15
17. Screw in the manometer at the removal
position of the bleeder screw by turning it
clockwise.
The filter vessel is prepared.

Mounting the pump on the base plate

1. Insert the threaded screws of the screw
set for fastening the pump
into the two hexagonal holes in the base
plate .
9
2. Place the pump
that the threads protrude through the
fastening opening in the pump base.
3. Push the washer and then the serrated
lock washer over the screw thread.
around the valve
5
on the valve
18
13
.
from below
10
on the base plate
3
7
9
10
with
11
so
9
39