Assembly
2. Mounting supports and joint fixture
1. Confirm which is the front and rear of stand base .
The side to which the poles are closer is the rear.
2. Slip the left and right supports onto the poles of
stand base from the top so that the display mounting
fixtures face the front.
3.
Mount joint fixture .
Loosely insert 1 joint fixture screw to the rear of
each support (left and right).
Insert the joint fixture on the screws from above,
with the clamp mounting holes facing the rear.
Finish tightening the joint fixture screws which
were previously loosely inserted.
•
The screws should be securely tightened to the torque
given below.
(1.2~1.5 N•m)
18
Front
Stand base
Display mounting fixtures
Front
Stand base
Clamp mounting holes
Front
Supports
Poles
Rear
Supports
Rear
Joint fixture
Joint fixture
screws
Rear