Panasonic TY-SP37P8W-K Instrucciones De Instalación página 3

3. Attach the speakers to the
Plasma Display.
Hook
• Insert the hooks and pin on the top and bottom
mounting brackets simultaneously into the slots at
the rear of the plasma display, and then lower the
speaker into place.
• Attach the left speaker in the same way.
5. Connect the speaker cables.
Preparing the ends of the
speaker cables
• After preparing the ends of the speaker cables, connect them as shown.
• The red cable is for the (+) side and the black cable is for the (-) side. Do not connect the cables to the wrong sides.
• When connecting the speaker cable, make sure that the core of the cord does not short.
Notes on use
1. If connecting to an external amplifier that exceeds the
rated input for the speakers, keep the amplifier volume
suitably low to protect the speakers from damage. If any
problems occur with speaker operation, disconnect the
mains lead of the amplifier and consult a qualified service
technician.
2. Do not place the speakers in the following places:
• Areas that are exposed to direct sunlight
• Near heaters or other heat sources
• Areas subject to high humidity
Slot
Rear of
Plasma Display
1. Press down on the lever.
Remove while
twisting
4. Secure the speakers in
place.
• Secure the top and bottom mounting brackets by
tightening the bracket mounting screws.
• Secure the left speaker in the same way.
• To change the amount of clearance between the
speakers and the display, loosen the bracket
mounting screws, make adjustments as desired,
and then tighten the screws.
• Tighten the bracket mounting screws securely so
that the speakers are not loose and do not rattle.
2. Insert the
cable.
3. Release the lever.
3. This set is equipped with magnetic resistant speakers.
However be careful not to place it near a CRT as it may
cause color patches.
4. To clean the speakers, wipe them with a soft cloth. If
they are extremely dirty, wipe them with a cloth that has
been soaked in a small amount of household detergent,
and then wipe them dry with a separate cloth.
• Do not use solvents such as alcohol or thinner.
• If using chemically-treated cloths, follow the
instructions supplied with the cloth packaging.
Bracket mounting
screw
Rear of Plasma Display
1. Push down the lever.
2. Insert
the cable.
3. Return the lever to its
normal position.
3