Detailed View; Led Indication - SilverStone DATA CENTER Serie Manual De Instrucciones

Introduction

1.6 Detailed View

1.6.1 LED indication

Flashing Blue
1.6.2 Power ON/OFF Procedure
• Connect the power supply to your device first and only then plug it into the wall socket. To turn on the
device, press the power switch to start up the system. It will take about 1-2 minutes for the device to
go online but the green system LED will indicate when the system is ready.
• To safely turn off the device, press and hold the power switch for 3 seconds until the green system LED
turns off. The system will then shut down all services and about 20 seconds later, it will power down.
• If for some reasons the system is unresponsive, press and hold the power switch for 6 seconds to
forcefully shut down the system and cut off the power.
Note
• If the device is not in use for longer periods of time, it is recommended to turn off the device and remove
the power supply from the wall socket.
Label
DC 5V
eSATA
100 / 1000Mbit
Reset
LED Status Meaning
System is starting up
Blue System ready
Orange System error (unable to start up system)
Description
Power button
Power receptacle
USB 2.0 host port
eSATA host port
Gigabit Ethernet port
System reset button
Security lock slot
4