Troubleshooting - NATURE & DECOUVERTES 60158450 Manual De Instrucciones

FUNCTION CHARACTERISTICS
Mist button usage
• Press once: The diffuser will switch on.
Ambient lighting will activate and the mist will
start to rise from the nozzle immediately.
• Press twice: This activates the intermittent
mist setting mode. The diffuser will now mist
for 30 seconds, stop for 30 seconds and
repeat.
• Press thrice: Pressing the power button thrice
will switch off the diffuser.
The light and mist will switch off.
INSTALLATION MANUAL
• Please open the top cover.
• Place the diffuser on a firm and flat place, in
upright direction.
Then pull the cover upward carefully.
• Detach the splash guard cover from the water
tank.
• Add around 120ml tap water inside the water
tank
• Connect the adaptor to the DC plug before
filling water into the water tank.
Step 1: Add water to the water tank with a
suitable measuring cup until the water level is
at the red marker.
Step 2: Add 1-2 drops of your favourite
fragrance or essential oil into the water. Avoid
essence oil or fragrance drop on to the shell
surface, in case of machine paint peeling off.
To connect the power source
• Connect the adaptor to the DC plug and then connect the adaptor to the power source.
• Never plug into the mains first.
• For essential oil / fragrance, we suggest to use water-soluble one.
Water shortage protection
When Aroma Diffuser water levels become too
low, the Aroma Diffuser will automatically turn
off. When Aroma Diffuser works continuously 4
hours, it will automatically turn off as well. This
will protect the atomiser from being burnt or
broken.
Overheating protection
If the machine over heats abnormally it will
automatically turn off.
Water capacity:
About 120ml.
CAUTION: Please do not exceed the max water
line when filling water in side, one or two drops
of essential oil is enough for 120ml water.
• Attach the splash guard cover to the main
body correctly.
• Do not operate without water. Turn off the
diffuser when the water tank is empty.
• Never fill the water tank directly from the water
tap, it could cause damage to the diffuser.
• In case of water exceeding the red marker gui-
deline, pour out the excessive water, avoiding
the air outlet.
• Close the top cover
• Insert the adaptor plug into household power
socket.
10

TROUBLESHOOTING

Problem Possible cause
There is an insufficient amount of
water in the water tank.
Unit will not switch
on
The power cable may not be
connected properly.
There is an insufficient amount of
water in the water tank
Water is exceeding the max. water
level line
No mist being
produced
The lid is not positioned correctly on
or mist volume
the unit
seems
abnormal
There is a build-up of dirt and oil on
the ceramic disc
The air suction part underneath the
unit is blocked or dirty
The lid is not positioned correctly on
the unit.
Water is leaking The unit has been knocked or tipped
from the product over.
The temperature is low or there is
high humidity.
Solutions
Fill the water tank with water up to the max.
Fill line. Be careful not to over fill the unit with
water.
Disconnect cable and reconnect carefully.
Fill the tank with water up to the max. Fill line.
Be careful not to overfill the unit with water.
Pour our excess water. The water must not
eed the
exc red marker.
Remove cover and replace correctly so mist can
release properly
Please refer to maintenance instructions on how
to clean the ceramic disc
Clean the suction part of any dirt as restricted
air flow will affect the mist
Remove cover and replace correctly so mist can
release properly.
Follow accidental leakage instructions.
Under these conditions the mist may condense
quickly into water droplets.
11