Walther Top point II Manual Del Operador página 2

2. Mounting
Your sight is delivered with a pair of mount rings which fit all
normal scope bases of the Weaver-type with a width of 22
mm. A minimum eye relief (the distance between the pupil
of the eye and the image lens) of 3 inches should always be
kept. Mount the sight onto your gun in a way that the eleva-
tion screw is positioned on top of the gun, while the windage
screw is positioned on the right side of the gun.
3. Operation and adjustment
The combined on/off-rotary switch and brightness regulator of
the electronic Walther red-dot-sight "Top Point" is positioned
on the top side of the sightbody. When the switch is on one
of the positions between 1 and 11, a dot of light of different
intensity is projected onto the lens. The lowest setting "0" is
the "OFF" position. Simply place the red dot over the target
when shooting.
3.1 Battery
The Walther Top Point II is powered by a 3 volt lithium battery
(CR 2032 or similar type). If the red dot gets slowly darker or
even invisible then it is time for a battery change. To insert
the battery, unscrew the battery compartment lid (cover
of the on/off rotary switch) with a coin while holding the
serrated part of the numbered knob. Insert new battery with
the positive pole (+) showing up, then replace the battery
compartment lid.
- 2 -
fastening
screws
mount rings fixed
on the sight
locking screw
on-/off switch and
brightness
adjustment
battery
compartment
lid
graduation
battery
compart-
ment lid
Battery
on-/off switch and
brightness regulator