Publicidad
Idiomas disponibles
Idiomas disponibles
3.2 Sight adjustment
Switch on the red dot by turning the on/off-rotary switch and
set its brightness to a degree ideally suited for you. Remove
the protective caps on the windage and elevation screw.In
order to adjust the point of impact of the gun, the appropriate
screw is to be turned into the desired direction. Each click of
the adjustment screws changes the point of impact by 1/3
MOA—.93 mm on 10 m or 9.3 mm on 100 m (.150 in. on
50 yards).
(MOA stands for minute of angle, 1 MOA covers 1 inch at
100 yards)
Adjustment
point of bullet impact high:
point of bullet impact low:
point of bullet impact right: turn windage adjustment screw clockwise
point of bullet impact left:
CAUTION:
!
4. Care and maintenance
Protect your sight from any mechanical damage caused by impact and always make sure
that the entire gun is not exposed to impact or thrust. If in doubt, always check the proper
adjustment of the gun. The sightbody and the mounting of the lens may be cleaned from
dust and dirt by using a clean, soft cloth which has been dampened with water. The lens
may be cleaned from dust with a soft optical brush, while fingerprints and dirt can be remo-
ved from it by using a lens cleaning cloth (moisturized with some lens cleaning fluid).
turn elevation adjustment screw clockwise
turn elevation adjustment screw counter-clockwise
turn windage adjustment screw counter-clockwise
Always follow the rules for safe gun handling. Always
ensure that the backstop is adequate for your shooting,
and always wear protective shooting glasses.
- 3 -
Windage
adjustment
Elevation
adjustment
UP
UP
Publicidad
