Key Automation EGKTB1 Manual Del Usuario página 7

Teclado táctil via bus
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
The factory master code is 123 and can be changed, but must remain 3 digits. If you want to
increase the number of digits, please refer to section 4.3 and perform this procedure before
section 4.4 and 4.5
DESCRIPTION
Press the numbers 123
Press the numbers 123
NB: if the code is incorrect, the keypad turns RED. If there is no connection or too few or too many digits
are entered, the keypad turns ORANGE.
4.4 INCREASING THE NUMBER OF MASTER CODE DIGITS
It is possible to increase the number of master code digits, up to a maximum of 6, to increase security.
The operation must be performed after pairing the components, but before modifying the master code, so
decide in advance the number of digits you want to use. It is not possible to have three digits mixed with
others with four, five or six digits.
DESCRIZIONE
Tenere premuti i tasti
diventa BLU
Enter the master code followed by
ORANGE.
Enter the number of digits which will form the new master code
followed by twice
Repeat the number of digits which will form the new master
code followed by twice
4.5 REPLACING THE MASTER CODE
DESCRIPTION
If you press and hold the
the keypad turns BLUE
Enter the old code followed by
then by
.
The keypad turns GREEN.
Enter new code twice, then by
The keypad turns GREEN.
WARNING: Do not forget the master code because it cannot be reset via the keypad for security reasons.
4.6 ADDING A CODE
DESCRIPTION
If you press and hold the
the keypad turns BLUE
Enter the master code followed by
ORANGE
Enter
new code
The new code is added
NB: it possible to add other codes in the same way, but wait until the colour of the keypad turns to the
one set.
in sequence to active the K1 relay
in sequence to active the K2 relay
+
per più di 5 secondi, la tastiera
. The keypad turns
+ once
. The keypad turns YELLOW.
+ once
. The keypad turns GREEN.
+
keys for more than 5 seconds,
and the new code twice,
.
+
keys for more than 5 seconds,
, the keypad turns
twice.
EXAMPLE COLOUR
123
GREEN
123
GREEN
ESEMPIO COLORE
BLU
+
5 sec
123
ARANCIO
YELLOW
4
+
+
4
+
+
GREEN
EXAMPLE COLOUR
BLUE
+
5 sec
123
GREEN
456
YELLOW
GREEN
456
EXAMPLE COLOUR
+
5 sec
BLUE
ORANGE
123
YELLOW
369
GREEN
369
BEEP
+
>1s
+
>1s
BEEP
>1s
+
>1s
> 1s x3
+
>1s
BEEP
>1s
+
>1s
> 1s x3
+
>1s
BEEP
> 1 s
+
> 1s
> 1s x3
+
> 1s

Publicidad

Tabla de contenido
loading

Productos relacionados para Key Automation EGKTB1

Este manual también es adecuado para:

Egkd2

Tabla de contenido