Cleaning And Care - Genie LA 402 Instrucciones De Funcionamiento

Clearing a blockage of the film
1. This machine is equipped with a film blockage function in order to resolve any
blockage of the film. Such function is featured by ABS button on BACK SIDE
of the laminator.
2. Please switch off the machine immediately by setting the switch to '"O"' and
pull out the plug from the mains socket outlet, let the machine to cool down
briefly (for hot laminating) and push the 'ABS' anti-film blockage button on
back as direction indicated by the arrow sign, whenever there is a blockage of
the film.
3. Hold the ABS switch firmly with one hand and pull out the film completely from
the machine's feed opening or delivery opening with the other hand.
4. After you have resolved the blockage of the film and released the ABS switch,
this will go back to its starting position again. Now you can use the machine
again completely.
5. Please contact our service hot line if there is a blockage of the film again.

Cleaning and care

1. Please pull out the plug from the mains socket outlet always, in order to clean
the machine. Take care while doing so that the plug does not come into
contact with any liquids.
2. Allow the machine to cool down before cleaning it.
3. Clean the machine with a slighly moist, soft cloth. Do not use any caustic or
abrasive cleaning agents while doing so.
Delivery:
Laminator GENIE LA 402
Instruction manual
Technical data
Mains voltage (V)
Consumption
Laminating width
Size of the machine (mm)
Film of utilizable thickness
(microns)
Heating up time
Speed
220 V to 240 V, 50 Hz
210W
230 mm
348 x 120 x71.5 approx.
80 minimum, 100
maximum
3-5 min. approx..
250 mm / min
8