Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Rotate the thumb wheel on the left side of the
take-up spindle towards the rear of the printer until
the ribbon is pulled tight across the printhead.
(See Figure 8)
8. Verify that the media is loaded and ready to print
and close the printer cover.
9. Press the Feed button to have the printer feed a
minimum of 10 cm (4 inches) of media to remove
slack and ribbon wrinkle and to align the ribbon on
the spindles.
10. Change the print mode setting from direct thermal
printing to thermal transfer to set the printer's
temperature profiles for thermal transfer media. This
can be done with the printer driver, application
software or printer programming commands. Your
printer is now ready to print.
PRINTER CONFIGURATION LABEL
1.
Before connecting the printer to your computer,
make sure the printer is in proper working order. This
can be done by printing a configuration status label.
2. Made sure the media is properly loaded and the
top cover of the printer is closed. Turn the printer
power on. If the printer initializes with the status light
blinking green (pause mode), press the Feed button
once to set the printer to Read (to print) mode.
3. Press the Feed button two to three times to allow
the printer to calibrate the printer for the installed
media. The printer may feed several labels during
this process.
4. When the status light is solid green, press and hold
the Feed button until the status light flashes once.
5. Release the Feed button. A configuration label will
print. (See Figure 9)
PAGE 5 OF 18
LOADING RIBBON CONTINUED
PRINTING
Figure 8
Figure 9
0517 IH-2526
Publicidad
Tabla de contenido
