Connection To The Water Supply; Conversion To A Different Type Of Gas; Commissioning; Instructions For Use - KBS DPBE40LC Instrucciones Para Instalación, Uso Y Mantenimiento

• Connect the power supply cable to the
terminal board as shown in the wiring dia-
gram supplied with the appliance.
• Secure the power supply cable with the
cable clamp.
• Protect the power supply cable on the out-
side of the appliance with a rigid plastic or
metal pipe.
• If the power supply cable is damaged, it
must be replaced by the manufacturer or
the technical after-sales service or, in any
case, by a suitably qualified technician, so
as to avoid any risk whatsoever.
PROTECTIVE EARTH AND EARTH BON-
DING CONNECTIONS
Connect the appliance to an efficient ground
circuit. Connect the earth conductor to the
terminal with the symbol
the main terminal board.
Connect the metal structure of the applian-
ce to the equipotential node. Connect the
conductor to the terminal with the symbol
on the outside part of the bottom.
• This symbol indicates that the appliance
must be included in an equipotential sy-
stem connected in compliance with cur-
rent regulations.

CONNECTION TO THE WATER SUPPLY

The appliance must be connected to a po-
table water supply.
• Install a mechanical filter and a shut-off
valve upstream of the appliance in an ea-
sily accessible point.
• Make sure the water circuit is free from
ferrous particles before connecting the fil-
ter and the appliance.
• Seal any unused connectors with a plug.
• Once the appliance has been installed,
check for leaks at the connection points.
• Hot water connection: the water tempera-
ture must not exceed 60°C.
• The water inlet pressure must be betwe-
en 150 kPa and 300 kPa. Use a pressure
• The appliance is intended to be perma-
12
13
See Chapter " INSTRUCTIONS FOR MAIN-
TENANCE".

REMINDERS FOR THE USER

The manufacturer will not be liable for
any damage or injury resulting from fai-
lure to observe the following rules.
located next to
• Read this manual carefully. It provides im-
• Keep this manual in a safe place known to
• Installation, conversion to a different type
• For after-sales service, contact technical
• Have the appliance serviced at least twice
• The appliance is designed for professional
• The appliance is to be used for cooking
reducer if the inlet pressure is above the
maximum permitted level.
nently connected to the mains water sup-
ply and not via disconnectable fittings.
CONVERSION TO A DIFFERENT
TYPE OF GAS

COMMISSIONING

INSTRUCTIONS FOR USE

portant information for safe installation,
use and maintenance of the appliance.
all users so that it can be consulted throu-
ghout the working life of the appliance.
of gas and appliance maintenance must
be carried out by qualified technicians au-
thorized by the manufacturer, in complian-
ce with current safety standards and the
instructions given in this manual.
assistance centers authorized by the ma-
nufacturer and demand the use of original
spare parts.
a year. The manufacturer recommends ta-
king out a service contract.
use and must be operated by trained per-
sonnel.
food as specified in the prescriptions for
use. Any other use is considered to be im-
proper.
7