Pegasus 66289W-6101 Guía De Instalación Y Cuidado página 6

Installation (continued)
3
Preparing the pop-up assembly
□
Remove the stopper (G) and ange (H).
□
Screw the nut (I) all the way down, and push
the gasket (J) down.
I
J
5
Installing the horizontal rod,
stopper, and strap
□
Remove the pivot nut (L).
□
Install the horizontal rod (M) and stopper (G), as
shown (1).
□
Hand tighten the pivot nut (L).
□
Attach the horizontal rod (M) to the strap (P)
using the clip (N).
G
H
4
Installing the pop-up body and
pop-up flange
□
Apply silicone to the underside of the ange (H).
□
Insert the pop-up body (K) into the sink. Screw
the ange (H) onto the pop-up body (K). The
pivot hole (1) must face the back of the sink.
□
Use the groove joint pliers to tighten the nut (J),
but do not over tighten. Do not turn the pop-up
body (K) while tightening the nut (J) or the
sealant may not seal properly. Clean away any
excess putty.
G
6
H
K
1
J
P
N
M
L
1