Publicidad
BOTTOM MOUNTING
INSTRUCTIONS
STEP 1
Attach bottom mount brackets
to front and rear of each slide
using (8) M4x10 screws
(See Fig 1).
STEP 2
Place template on cabinet floor
and pre-drill hole locations
(See Fig 2).
3
32
3
mm
STEP 3
Attach slide to the floor using
(4) #8x5/8" deep thread truss
head screws on each slide
(See Fig 3).
STEP 4
Install release levers and rear
slide brackets to the bottom of
the unit (See Fig 4).
NOTE: If you are mounting to
a cabinet door, skip to Page 4
at this time.
STEP 5
Place the basket on top of the
slides and push back until the
basket locks under the tab
at the rear and at the button
on the side. You should hear
the button click when fully
engaged (See Fig 5).
2
FIGURE 1
FIGURE 4
#6x3/4" Flat Head Screws (4)
Customer Service: 800-626-1126 | rev-a-shelf.com
FIGURE 3
Euro Screws (4)
FIGURE 5
FIGURE 2
Publicidad
