Safety Advice; Cleaning Instructions; Before Assembly - Palram Harmony 6x8 Manual De Instrucciones

IMPORTANT
Please read these instructions carefully before you start to assemble this product
.
Please
carry out the steps in the order set out
in
these instructions.
Keep these
instructions
in
a
safe place
for future
reference.
Safety Advice
For
safety purposes we strongly recommend the product to
be
assembled by at least two people.
Some parts may have sharp edges.
Please be
careful when handling components. Always wear
gloves,
eye
protection, and long
sleeves
when assembling or performing any maintenance
on
your
product.
Do
not attempt to assemble the product
in
windy or wet conditions.
Do
not attempt to assemble the product if you
are
tired,
have
taken drugs,
medications or alcohol, or if you
are
prone to dizzy
spells.
Dispose
of
all plastic bags safely
-
keep
them
away
from children's
reach.
Keep
children away from the assembly
area.
When using
a
stepladder or power tools, make sure that you
are
following
the manufacturer's
safety advice.
Keep
roof
and
gutters
clear
of
snow,
dirt
& leaves.
Heavy snow load on the roof
can make
it unsafe to stand below or nearby.
Do
not
lean
against or push the product during construction.
Hot items
such as
recently
used
grills, blowtorches etc. must not
be
stored inside the product.
Heavy or sharp articles should not
be
leaned against the wall panels.
Make Sure there are no hidden pipes or cables
in
the ground before inserting the
pegs (not
supplied)
Do
not touch overhead power cables with the aluminum profiles.
If color was scratched during assembly it
can be
fixed.
Note:This product
must be anchored on to
a
leveled surface and solid
foundation to
ensure its
stability.
Make sure
that
screws
and anchors
are
compatible with foundation type.
Make sure
that there
are
no
obstructions between the assembly
area
and the final position.
Cleaning
Instructions
In
order to clean the product,
use
a
mild detergent solution and rinse with cold clean
water.
Do not
use
acetone, abrasive cleaners, or other special detergents to clean the panels.
Clean
the product once assembly
is
complete.
Before Assembly
Choose your site carefully before beginning assembly.
The
ground surface must be perfectly flat and leveled.
Choose
a
sunny
area,
away from overhanging trees.
Do
not position your product
in an area
exposed to excessive winds.
The
product must
be
positioned and fixed onto
a
flat leveled
surface.
We
strongly recommend to secure this product directly onto
a
solid foundation.
Use
the pre-drilled
holes in
the
steel base.
Complete site
preparation before unpacking parts and beginning
assembly.
Sort
the parts and check against the content parts
list.
Parts should be laid
out
close at hand. Keep
all
small parts (screws etc.) in
a
bowl
so
they
do not get
lost.
Please
consult your
local
authorities if
any
permits
are
required prior to constructing the
product.