Tabla de contenido
Publicidad
EN
INFORMATION
SAFETY ADVICE
It is of utmost importance to assemble all of the parts according to the directions.
•
•
Do not skip any steps.
Always wear work gloves during panel sliding.
• •
Always wear shoes and safety goggles when working with extruded aluminium.
• •
If using a step ladder or power tools make sure that you follow the manufacturer's safety advice.
• •
Do not touch overhead power cables with the aluminium profiles.
• •
Do not attempt to assemble the product in windy or wet conditions.
• •
Do not climb or stand on the roof.
• •
Dispose of all plastic bags. Keep them out of reach of small children.
• •
Keep children away from the assembly area.
• •
Do not lean against or push the products during construction.
• •
Do not position your product in an area exposed to excessive winds.
• •
Do not attempt to assemble this product if you are tired, have taken drugs or alcohol or if you
• •
are prone to dizzy spells.
Hot items such as recently used grills, blowtorches etc. must not be stored in the product.
• •
Make sure there are no hidden pipes or cables in the ground before anchoring to foundation.
• •
This product is designed to be used mainly as a greenhouse.
• •
Make sure to anchor the product directly to a solid foundation to increase the product's
• •
stability and wind resistance in areas with severe weather conditions. Make sure that there
are no obstructions between the assembly area and the final position of the product.
CARE & MAINTENANCE
When your product needs to be cleaned, use a soft cloth and rinse with cold clean water.
•
•
DO NOT use acetone, abrasive cleaners or other special detergents to clean the panels.
• •
Clean the product once assembly is complete.
• •
BEFORE ASSEMBLY
Selecting a site:
•
•
- Choose your site carefully before beginning assembly.
- Choose a sunny position away from overhanging trees.
- The product must be positioned and fixed on a flat level surface.
The product must be secured directly to a solid foundation.
• •
This is a multi-part assembly best achieved by two people. Allow at least half a day for the
• •
assembly process.
Take all components & parts out of the packages. Sort the parts and check against the content
• •
parts list.
Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so they do
• •
not get lost.
Please note multi-sided profiles are used in this product. As a result some holes in the profiles are
• •
not used during assembly.
Please review entire instructions before starting. Carry out the assembly steps in exact order.
• •
Please consult your local authorities if any permits are required prior to constructing the product.
• •
Please ensure you have sufficient side space for inserting the roof panels during the assembly
• •
process.
IMPORTANT ASSEMBLY STEPS
When encountering this information icon during assembly, please refer
the relevant assembly step for important additional comments.
Steps 5+6:
If you have purchased Sun Room 8', you should use the entire 7802 panel.
If you have purchased Sun Room 6', you should cut panel 7802 to size, in
accordance with illustration 6a.
Step 7:
Please decide your preferred window location. Available options are shown
in the illustration.
Step 17:
If the window doesn't close properly, please release the screws, adjust the
profile and re-tighten the screws.
Please tighten all screws when completing assembly.
Publicidad
Tabla de contenido
