WARNING. When using the machine the safety rules must be followed. For your own safety and
that of bystanders please read these instructions before operating the machine. Please keep the
instructions safe for later use.
Explanation of Symbols on your product
Warning
Read the user instructions carefully to
make sure you understand all the controls
and what they do.
Keep bystanders away. Do not operate
10m
whilst people especially children or pets
are in the area.
General
1. This product is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning the use of the
product by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the product. Local regulations may
restrict the age of the operator.
2. Never allow children or people unfamiliar with the
instructions to use the machine.
3. Stop using the machine while people, especially
children, or pets are nearby.
4. Only use the trimmer in the manner and for the
functions described in these instructions.
5. Never operate the trimmer when you are tired, ill or
under the influence of alcohol, drugs or medicine.
6. The operator or user is responsible for accidents or
hazards occurring to other people or their property.
7. This product is intended to be used by a standing
operator, primarily for cutting grass and other ground
level plants.
8. Keep bystanders away. Do not operate whilst
people especially children or pets are in the area.
Electrical
1. The use of a Residual Current Device (R.C.D.)
with a tripping current of not more than 30mA is
recommended. Even with a R.C.D. installed
100% safety cannot be guaranteed and safe
working practice must be followed at all times.
Check your R.C.D. every time you use it.
2.
Before use, examine the cable for signs of damage
or ageing. If the cable is found to be defective, take
the product to an Authorised Service Centre and
have the cable replaced.
3. Do not use the trimmer if the electric cables are
damaged or worn.
4. Immediately disconnect from the mains electricity
supply if the cable is cut, or the insulation is
damaged. Do not touch the electric cable until
the electrical supply has been disconnected. Do
not repair a cut or damaged cable. Replace it
with a new one.
5. Your extension cable must be uncoiled, coiled
cables can overheat and reduce the efficiency of
Safety
Wear eye protection
Do not operate in the rain or leave the
product outdoors while it is raining.
Switch off! Remove plug from mains
before adjusting, cleaning or if cable is
entangled or damaged. Keep the cable
away from the cutting parts.
Warning
The cutting line continues to rotate after the machine
has been switched off.
your trimmer.
6. Keep the cable clear of the cutting area and
obstacles at all times.
7. Do not pull cable around sharp objects.
8. Always switch off at the mains before
disconnecting any plug, cable connector or
extension cable.
9. Never pull on the cable to disconnect any of the plugs.
10. Switch off, remove plug from mains and examine
electric supply cable for damage or ageing before
winding cable for storage. Do not repair a
damaged cable, replace it with a new one. Use
only Flymo replacement cable.
11. Always wind cable carefully, avoiding kinking.
12.Use only on AC mains supply voltage shown on
the product rating label.
13. Flymo trimmers are double insulated to EN60335.
Under no circumstance should an earth be
connected to any part of the trimmer.
Cables
If you want to use an extension cable when operating your
product, only the following cable dimentions should be used.
2
- 1.0 mm
: max length 40 m
2
- 1.5 mm
: max length 60 m
2
- 2.5 mm
: max length 100 m
Minimum rating
1.00mm
2
size cable 10 amps 250 volts AC
1. Mains cables and extensions are available from your
local Approved Service Centre.
2. Only use extension cables specifically designed for
outdoor use and which conform to one of the following
specifications: Ordinary rubber (60245 IEC 53), Ordinary
PVC (60227 IEC 53) or Ordinary PCP (60245 IEC 57)
3. If the short connection lead is damaged, it must be
replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Preparation
1. While using your product always wear eye
protection, substantial footwear and long trousers.
Do not operate the equipment when barefoot or
wearing open sandals.
2. Before using the machine and after any impact,
check for signs of wear or damage and repair as
necessary.
3. Inspect the area to be cut before each use. Remove
ENGLISH - 1