Panini Vision X Manual Del Operador página 52

Ocultar thumbs Ver también para Vision X:
Tabla de contenido

Publicidad

Ink Jet Cartridge Installation
The following steps indicate how to install the Vision X AGP ink jet
cartridge.
Remove the new print cartridge from its package, and gently
remove the transparent tape covering the ink nozzles, being
careful not to touch the ink nozzles and electrical contacts.
Remove Vision X inner cover (see section 4.3)
Push the new cartridge down firmly into its cradle slot, and close
the rear cradle lever.
Insert the inner cover
Cleaning the Contact Image Sensors
In addition to following the basic cleaning instructions provided in section 5.2 of the Operator Manual, Panini
recommends that you occasionally inspect the images for the presence of any streaking due to residual ink
on the Contact Image Sensors (CIS) glass. If so, use the Panini cleaning cloth (Panini P/N: GS- 00020-00)
to clean the CIS surface.
Cleaning the Ink Jet Cartridge
Fibers, such as cotton or paper, dried ink plugs or crust, or excess ink puddles on the nozzle plate can
obstruct ink droplets or cause ink droplets to deflect from the desired trajectory, resulting in a degraded print
quality. If this happens, follow the instructions below:
OPERATOR MANUAL
Page 51
** Replaces section 3.5
** Addition to section 5.2
** Replaces section 5.3
Vision X AGP Addendum

Publicidad

Tabla de contenido
loading

Tabla de contenido