Towing Products 26102 Instrucciones De Instalación página 4

Round Bar Set Up Locations
(Standard Coupler)
Approximate desired
working range on a 6"
tall frame.
12"-13"
Figure 7 – Cam Arm Approximate Location for Round Bar Weight Distribution kits
Round Bar Set up Locations
(Bottom Mounted Coupler)
Approximate desired
working range on a 6"
tall frame.
12"-13"
CHAIN SHOULD
BE AS STRAIGHT
UP AND DOWN
AS POSSIBLE
If you have a bottom mounted coupler it may be necessary for you to tilt the ball mount as far forward
towards the front of the tow vehicle as possible.
The Measurements in figures 6, 6A, 7 & 7A are guidelines, adjustment of the cam arm length via the adjustment nut (Figure 5)
may be required after hookup in later instructions of this manual Cequent Performance Products, Inc. is not responsible for
damage incurred due to disregarding any part of this manual.
©
2010 Cequent Performance Products, Inc.
Installation Instructions
REESE Dual Cam HP
High-Performance Sway Control
Figure 7A – Cam Arm Approximate Location for Round Bar Weight Distribution kits
CAUTION:
FROM MARK ON COUPLER
ALONG SIDE OF FRAME
Sheet 4 of 33 26102IN
18"
19-1/8"
04/29/14 Rev. K