Attaching The Live Center; Installing The Faceplate; Installing The Tool Holder; Securing The Lathe To A Work Surface Or Stand - Luna BWL 406 Manual Del Usuario

Knockout Bar
The knockout bar is used to remove the spur center from the head-
stock spindle. Insert knockout bar into hole at opposite side from
spur center. (See Fig.4)
Knockout bar
Attaching Live Center On the Tailstock
Insert the live center, with a No. 2 Morse Taper shank into the tail-
stock spindle. (See Fig.5)
Live center
To remove the live center from the tailstock spindle, loosen locking
arm and rotate the hand wheel counter clockwise to retract spindle
into the body of the tailstock. The live center will be pushed out of
the spindle. (See Fig.6)
Locking arm
Fig. 04
Locking arm
Tailstock spindle
Fig. 05
Fig. 06
Installing The Faceplate to the Headstock
Thread the faceplate clockwise on to the headstock spindle. Engage
the spindle lock and stop the spindle from turning. Tighten the face-
plate with the supplied wrench. (See Fig.7)
Warning! Disengage spindle lock before turning the machine on.
Spindle lock
Installing Tool Holder On the Lathe Bed
Located the tool holder from the carton, and install it onto the lathe
bed with two pan head screws. (See Fig.8)
Pan head screw
Secure Lathe to a Solid Work Surface
The lathe must be attached to a solid work surface or stand. Four
mounting holes are easily accessible at the base of the lathe. (See
Fig.9)
42
Faceplate
Tool holder
Mounting holes
Fig. 07
Fig. 08
Fig. 09