Craftsman CMCL030 Manual De Instructiones página 9

Wall Mounting
These chargers are designed to be wall mountable or to
sit upright on a table or work surface. If wall mounting,
locate the charger within reach of an electrical outlet,
and away from a corner or other obstructions which may
impede air flow. Use the back of the charger as a template
for the location of the mounting screws on the wall. Mount
the charger securely using drywall screws (purchased
separately) at least 1" (25.4 mm) long, with a screw head
diameter of 0.28–0.35" (7–9 mm), screwed into wood to an
optimal depth leaving approximately 7/32" (5.5 mm) of the
screw exposed. Align the slots on the back of the charger
with the exposed screws and fully engage them in the slots.
Versatrack
CRAFTSMAN chargers can be mounted to the wall using
CRAFTSMAN Versatrack Trackwall. Hooks and accessories
are sold separately. Please refer to the Versatrack Trackwall
accessory sheet for further information.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.
Intended Use
This area light is designed for workspace lighting use.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from power
source and remove the battery pack before
making any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Installing and Removing the Battery Pack
(Fig. B)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
pack with the rails on the side of the tool and slide it into
the tool until the battery pack is firmly seated in the tool and
does not disengage.
9 into the tool, align the battery
To remove the battery pack from the tool, press the battery
pack release button 10 and firmly pull the battery pack
out of the tool. Insert it into the charger as described in the
charger section of this manual.
Fig. B
9
Tool Placement (Fig. C–E)
The area light can be used one of four ways.
• On a level surface as shown in Figure C.
• Hung from a joist or saw horse using the rafter hooks
as shown in Figure D.
• Mounted to a tripod using the mounting base
located on the bottom of the area light as shown in
Figure E. Refer to Screw Threads for further instruction.
• Mounted using the keyhole slots
bottom of the area light as shown in Figure E. Refer to
Keyhole Slots for further instruction.
Fig. C
Fig. D
4
English
10
4
5
located on the
5
7