Husqvarna 1365GN Manual Del Operario página 16

Maintenance
SPECiFiCATiONS
Starting Wattage .................. 8,125 watts
Wattage ......................... 6,500 watts
AC Load Current:
At 120 Volts .................... 54.1 Amps
At 240 Volts ..................... 27.0 Amps
Phase ............................. 1-phase
Rated Frequency .................... 60 Hertz
Fuel Tank Capacity ............... 7 U.S. gallons
Shipping Weight ..................... 205 Ibs.
GENERAL MAINTENANCE
RECOMMENDATIONS
The Owner/Operator is responsible for making sure
that all periodic maintenance tasks are completed on a
timely basis; that all discrepancies are corrected; and
that the unit is kept clean and properly stored. NEVER
operate a damaged or defective generator.
NOTE: Should you have questions about replacing
components on your Husqvarna generator, please call
1-877-224-0458 for assistance.
Engine Maintenance
See engine operator's manual for instructions.
I A CAUT, ON
1
Used motor oil has been shown to cause skin cancer in
certain laboratory animals.
Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN.
DON'T POLLUTE. CONSERVE
RESOURCES. RETURN USED OIL TO
COLLECTION CENTERS.
Generator Maintenance
Generator maintenance consists of keeping the unit
clean and dry. Operate and store the unit in a clean
dry environment where it will not be exposed to
excessive dust, dirt, moisture or any corrosive vapors.
Cooling air slots in the generator must not become
clogged with dirt, leaves or any other foreign material.
NOTE: DO NOT use a garden hose to clean
generator. Water can enter engine fuel system and
cause problems. In addition, if water enters generator
through cooling air slots, some of the water will be
retained in voids and cracks of the rotor and stator
winding insulation. Water and dirt buildup on the
generator internal windings will eventually decrease
the insulation resistance of these windings.
WARNING
WHEN ADJUSTING OR MAKING REPAIRS TO YOUR
GENERATOR
,, Disconnect the spark plug wire from the spark plug and
place the wire where it cannot contact spark plug.
WHEN TESTING FOR ENGINE SPARK
Use approved spark plug tester.
DO NOT check for spark with spark plug removed.
Fuel Valve Maintenance
The fuel valve is equipped with a fuel sediment cup,
screen, retaining ring and o-ring that need to be
cleaned every 6 months or 100 hours (whichever
occurs first).
1. Move fuel valve to"Off" position.
2. Remove sediment cup from fuel valve. Remove
o-ring, retaining ring and screen from fuel valve
(Figure 12).
Screen
Retaining Ring
O-ring
Sediment Cup -
O