Husqvarna 1365GN Manual Del Operario página 17

Storage
3. Wash sediment cup, o-ring, retaining ring, and
screen in a nonflammable solvent. Dry them
thoroughly.
4. Place screen, retaining ring, and o-ring into fuel
valve. Install sediment cup and tighten securely.
5. Move fuel valve to "On" position, and check for
leaks. Replace o-ring if there is any leakage.
Generator Cleaning
Use a damp cloth to wipe exterior surfaces clean.
I CAUTION
DO NOT expose generator to excessive moisture, dust,
dirt, or corrosive vapors.
DO NOT insert any objects through cooling slots.
Use a soft bristle brush to loosen caked on dirt or
oil.
Use a vacuum cleaner to pick up loose dirt and
debris.
Inspect cooling air slots and opening on generator.
These openings must be kept clean and
unobstructed.
Data Tag
Data tag information is very important if you need help
from our Customer Service Department or an
authorized service dealer.
The data tag (Figure 13) is located on the engine
support on the muffler side of the generator. For future
reference, please copy the model, revision, and serial
number of the generator in the space below.
MODEL I
REV NO i
SERIAL l
Copy Model
fNumber Here
Copy
Revision Here
"_ -_, Copy Serial
Number Here
1
STORAGE
The generator should be started at least once every
seven days and allowed to run at least 30 minutes. If
this cannot be done and you must store the unit for
more than 30 days, use the following guidelines to
prepare it for storage.
Generator Storage
Clean the generator as outlined in "Generator
Cleaning:'
Check that cooling air slots and openings on
generator are open and unobstructed.
WARNING
DO NOT place a storage cover over a hot generator.
Let equipment cool for a sufficient time before placing the
cover on the equipment.
Engine Storage
See engine operator's manual for instructions.
Other Storage Tips
• To prevent gum from forming in fuel system or on
essential carburetor parts, add fuel stabilizer into fuel
tank and fill with fresh fuel. Run the unit for several
minutes to circulate the additive through the
carburetor. The unit and fuel can then be stored for
up to 24 months. Fuel stabilizer can be purchased
locally.
DO NOT store fuel from one season to another
unless it has been treated as described above.
Replace fuel container if it starts to rust. Rust and/or
dirt in fuel can cause problems if it's used with this
unit.
Store unit in a clean and dry area.
O