Uline H - 6312 Manual De Instrucciones página 3

Ocultar thumbs Ver también para H - 6312:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: Before assembly, to avoid being locked
out of cabinet, remove the key for manual
entry from the battery compartment on the
back of the electronic lock.
1.
Place the back (1) on a protected surface.
The bottom flange should face upward.
(See Figure 1)
Flange faces upward
NOTE: When bolting the unit together, leave the
bolts slightly loose until step 7, unless otherwise
specified.
2. Attach the left side (2) to the back by placing flange
around the back and bolting the back and side
together with seven bolts and nuts. Be sure that the
lances on all shelf adjustment strips point in the
same direction. (See Figure 2)
3. Attach the top (7) to the unit by sliding the outer
flange over the back of the unit and the side flange
on the side panel of the unit. The threaded studs
should go through the holes in the top flange of the
side and fasten with three nuts. Attach the back to
the top using four bolts and nuts. (See Figure 3)
PAGE 3 OF 15
1
2
Flange goes
under back.
All lances point UP
on both back and
side.
ASSEMBLY
4. Attach the right side (3) to the back as in step 2.
Make sure the flange is around the back and that
the lances on the shelf adjustment strips are pointed
in the same direction as those on the back and left
side. Push the side panel up so the studs in the top
go through the holes in the top flange of side and
fasten with three nuts. (See Figure 4)
Figure 1
5. Attach the sill (5) to the sides. Place nut loosely on
each of the studs and slide the ends of the sill into
the slots on both sides of the unit. Then, securely
tighten the nuts. (See Figure 5)
Figure 2
6. Place rear flange of the bottom (6) into the bottom
lances of the back and sides. The flange with two
holes should face the front, hanging over the sill.
Insert bolts through the bottom and sill with the head
facing the front of the unit. Secure with two nuts.
(See Figure 6)
Figure 3
7
5
Nuts placed loosely
on studs of the sill.
Slide ends into the slots on
the bottom of the sides
6
Figure 4
3
Figure 5
Figure 6
0321 IH-6312

Publicidad

Tabla de contenido
loading

Tabla de contenido