Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Set the unit upright and tighten all nuts and bolts
around the entire unit.
8. Insert the shelves (4) at desired levels. (See Figure 7)
NOTE: To place the
shelves, tilt the shelf
slightly to the left or
right before inserting
into the unit.
9. Attach the left door (8)
to the unit by placing
the door on the hinges,
aligning the hinge holes,
dropping the hinge pins
(10) into the slots, then
placing the flat end of a
screwdriver on the hinge pins and tapping them in
with a hammer. (See Figure 8)
8
FRONT
Override Key
Cover Plate
PAGE 4 OF 15
ASSEMBLY CONTINUED
4
Figure 8
ELECTRONIC LOCK INSTRUCTIONS
Main Display
OPEN
1
2
3
4
5
6
7
8
9
Handle
Keypad
10. Attach the right door (9) to the unit the same way the
left door was attached. (See Figure 9)
NOTE: If having issues with doors aligning, it
may be due to cabinet not sitting level. Use
included nut driver to adjust leveling feet in
Figure 7
bottom front two corners. Nut driver should
insert through inside of cabinet down into feet
and adjust as needed.
10
11
11
11
11
11
11
11
01:52
Date and Time
Display
*
0
#
9
BACK
Reset
Button
Battery
Compartment
Figure 9
0321 IH-6312
Publicidad
Tabla de contenido
