Uline H - 6312 Manual De Instrucciones página 5

GETTING STARTED
1. The battery compartment is located on the back of
the electronic lock. To insert batteries, lift up on the
compression tab at the bottom of the compartment.
NOTE: The key for manual entry is located
within the battery compartment. Keep this key
in case of battery failure.
ENTERING SECURITY CODE
1. There are two preset codes, a personal and an
administrator. The factory presets are:
Personal (Pass 1): 1 2 3 4
Administrator (Pass 2): 1 2 3 4 5 6
2. Press # key. Display will read "––––––––."
3. Enter the code and press the # key. Once
confirmed, display will read OPEN.
4. To conceal code, press * after entering # key and
before entering code. To disable concealment,
press * twice.
NOTE: An alarm will sound if an incorrect code
is entered three times. Alarm will sound for one
minute, or until correct code is entered.
SETTING DATE AND TIME
NOTE: Date is displayed as year/month/day.
There is a circular display of days of the week
in the top right corner. Below that is the military
time. (See Figure 10)
1. Press *. Enter last two digits of the year. Enter two
digits of the month. Enter two digits of the day.
2. Enter day of week; i.e., Monday = 1, Sunday = 7.
3. Next, enter hour and minute as military time
(AM hours 01-12, PM hours 13-24).
Figure 10
16-12-12
Year
PAGE 5 OF 15
ELECTRONIC LOCK INSTRUCTIONS CONTINUED
Day of Week
MON
SUN
SAT
FRI
12:25
Month Day Military Time
KEY ENTRY
1. The key slot is located underneath the cover, next to
the handle. Remove cover by prying off from bottom.
2. Insert key into lock and turn counterclockwise.
3. While key is inserted, turn handle clockwise to
release lock.
CHANGING SECURITY CODE
1. Open door with the current desired code to change
(either personal or administrator).
2. With display reading OPEN, press *. Display will read
"––––––––."
3. Enter new code and press #. Display will read IN.
Code is now changed.
RESETTING PERSONAL CODE IF LOST
OR FORGOTTEN
1. Open cabinet using key.
2. When cabinet is open, personal code can be
changed by pushing red button on top left side of
lock.
3. After red button is pushed, enter new code and
press # again.
RETRIEVE OPEN DOOR RECORDS
1. Press #, enter code, press #. Display will read OPEN.
Then press 0.
2. Display will cycle through date, time and password
used (Pass 1 or Pass 2) on most recent opening.
Press 0 to scroll back through records.
TUE
WED
THU
1-800-295-5510
uline.com
0321 IH-6312