MRA F650GS Instrucciones De Montaje página 2

Read this manual carefully and check the parts list for completeness before you begin. We recommend that you have
Parts List:

1x Screen

6x Black screws M 5 x 16

2x Black screws M 5 x 20

8x Plastic washers
 2x Rubber nuts

2x Metal brackets
Stand your motorbike on a level, firm surface.
Remove the six screws and the original screen. NOTE: the
washers in the rubber nuts might fall out.
Mount the metal brackets with the screws, plastic
washers and rubber nuts, and align them (Fig. 1).
Position the new fairing screen onto your motorbike;
first, fasten it with the medium M5 x 20 screws, then
those on the metal bracket and then the outer screws,
each with the plastic washers (Fig. 2).
Tighten up all of the screws, and make sure they are still
tight from time to time.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at regular intervals.
Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or spirits to clean the screen as
MRA-Klement GmbH + Siemens Str. 6 + D-79331 Teningen
Thank you for buying a MRA Windshield.
your screen fitted by an authorised workshop.
Installing your screen :
they will damage it.
I N S T A L L A T I O N M A N U A L
F 6 5 0 / 8 0 0 G S
Tel.: +49 7663 9389 0 + Email: info@mra.de
Required Tools:

Allen key 3mm

Torx 25
P1
P2
© by MRA-Klement GmbH – 08/2011