Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3
Installation
Refer to the nearest Authorised Service Agent for
installation of the product. Make sure that the
electric and gas installations are in place before
calling the Authorised Service Agent to have the
product ready for operation. If not, call a qualified
electrician and fitter to have the required
arrangements made. The manufacturer shall not
be held responsible for damages arising from
procedures carried out by unauthorized persons
which may also void the warranty.
Preparation of location and electrical
installation for the product is under
customer's responsibility.
DANGER:
The product must be installed in
accordance with all local electrical
regulations.
DANGER:
Prior to installation, visually check if the
product has any defects on it. If so, do
not have it installed.
Damaged products cause risks for your
safety.
10/EN
Before installation
The appliance is intended for installation in
commercially available kitchen cabinets. A safety
distance must be left between the appliance and
the kitchen walls and furniture. See figure (values
in mm).
•
Surfaces, synthetic laminates and adhesives
used must be heat resistant (100 °C
minimum).
•
Kitchen cabinets must be set level and fixed.
•
If there is a drawer beneath the oven, a
shelf must be installed between oven and
drawer.
•
Carry the appliance with at least two
persons.
Do not install the appliance next to
refrigerators or freezers. The heat emitted
by the appliance will lead to an increased
energy consumption of cooling appliances.
The door and/or handle must not be used
for lifting or moving the appliance.
If the appliance has wire handles, push the
handles back into the side walls after
moving the appliance.
Publicidad
Tabla de contenido
