Specific Safety Rules - Makita 9227C Manual De Instrucciones

GROUNDING INSTRUCTIONS:
This tool should be grounded while in use to protect
the operator from electric shock. The tool is
equipped with a three-conductor cord and three-
prong grounding type plug to fit the proper
grounding type receptacle. The green (or green and
yellow) conductor in the cord is the grounding wire.
Never connect the green (or green and yellow) wire
to a live terminal. Your unit is for use on 120 volts
and has a plug that looks like Fig. "A".
Fig. A
Grounding
Blade
000088

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to polisher safety rules. If you use this tool unsafely
or incorrectly, you can suffer serious personal
injury.
1. Accessories must be rated for at least the
speed recommended on the tool warning label.
Wheels and other accessories running over rated
speed can fly apart and cause injury. Maximum
operating speed of accessories should be higher
than the highest no load speed marked on the
tool's nameplate.
2. Hold tool by insulated gripping surfaces when
performing an operation where the cutting
tool may contact hidden wiring or its own
cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
3. Check the backing pad carefully for cracks,
damage or
Replace cracked, damaged or deformed pad
immediately.
4. NEVER use tool with wood cutting blades or
other sawblades. Such blades when used on a
polisher frequently kick and cause loss of
control leading to personal injury.
5. Hold the tool firmly.
6. Keep hands away from rotating parts.
Cover of Grounded
Outlet Box
deformity before
7. Make sure the abrasive disc or wool bonnet is
not contacting the workpiece before the
switch is turned on.
8. When sanding metal surfaces, watch out for
flying sparks. Hold the tool so that sparks fly
away from
flammable materials.
9. Do not leave the tool running. Operate the tool
only when hand-held.
10. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
11. Check
supported.
12. Pay attention that the wheel continues to
rotate after the tool is switched off.
13. This tool has not been waterproofed, so do
not use water on the workpiece surface.
14. Ventilate your work area adequately when you
perform sanding operations.
15. Use of this tool to sand some products, paints
and
containing
appropriate respiratory protection.
USB047-4
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
operation.
4
you and other
that the workpiece
wood could expose
hazardous
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
revolutions or reciprocation per minute
persons or
is properly
user to dust
substances. Use
USD101-2