Techne HB-1D Manual Del Usuario página 18

Tabla de contenido

Publicidad

H B - 1 D O P E R A T O R ' S M A N U A L
Small Tube (3 x 44mm dia) assembly
Unscrew the tube end cap. Place the filters in the tube and replace the end
cap. Remove the spindle cap and the liquids appropriate to the protocol may then be
added through the hole in the spindle using a syringe. Replace the spindle cap and
press it onto the spindle so that it clicks into place.
The assembly is similar to the four tube assembly but the end caps do not have
to be at different ends of the carrier. Fix the tube into a multi-tube holder, using the
springs, and ensure that there are three tubes in the holder. The multi-tube holder will
not rotate properly if there are not three small tubes in it.
End
Cap
16 x 15ml Tube assembly
Unscrew the end cap from the tube. Place the filters and the liquids
appropriate to the protocol in the tube and replace the end cap.
Assemble the tubes into a multi-tube holder, using the spring clips. The multi-
tube holder will not rotate properly if it is not balanced properly. Preferably the multi-
tube holder should be filled copmletely even if all the tubes are not being used.
16
Tubes
Spring
Cap

Publicidad

Tabla de contenido
loading

Tabla de contenido