Troubleshooting - Cisco Linksys PLWK400 Guia Del Usuario

Linksys PLWK400
6. Click the Wireless Settings tab to change the wireless network name
(SSID), wireless security type, or passphrase/key
Settings are applied to the adapter(s) immediately Close the window to
exit the utility

Troubleshooting

Your wireless network device is not recognized by your network.
Try the following:
•
Make sure that the wireless device is turned on and that its wireless
networking is turned on
• If possible, position the PLW400 near the wireless device that you want
to connect
• Avoid obstructions (such as metal file cabinets, mirrors, and thick walls)
between the PLW400 and any wireless device you want to connect
If you have set up advanced security for the Powerline network, check the
following:
• Make sure all adapters on the Powerline network have been configured
with the same network password The network password must be
identical in order for them to communicate with each other See "Setting
up advanced security" on page 8" or "Using the Utility" on page 8
The Ethernet LED does not turn on after you connected a wired Ethernet
device to the Powerline adapter.
Follow these instructions:
1. Make sure that the Ethernet network cable is securely connected to the
adapter
2. Make sure that the Ethernet network cable is securely connected to the
network device you are connecting
Or:
1. Disconnect the adapter from the power outlet
2. Disconnect the Ethernet network cable from the adapter
3. Wait five seconds
4. Re-connect the Ethernet network cable to the adapter
5. Re-connect the adapter to the power outlet
Troubleshooting
10