Hg
N O M E R C U R Y
CAUTION: ELECTRONIC WASTE NOTICE
The product should not be disposed of with other household waste.
Check for the nearest authorized collection centers or authorized
recyclers. The correct disposal of end-of-life equipment will help
prevent negative consequences for the environment and human
health.
SUPPLIED PARTS
One (1) thermostat
•
Two (2) 6-32 mounting screws
•
Two (2) solderless connectors
•
Installation
TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN
POWER PANEL TO AVOID ELECTRICAL SHOCK.
All cables and connections must comply with local electrical codes.
•
This thermostat has tinned copper wires for line and load connections.
•
Special CO/ALR solderless connectors must be used if these wires will be
•
connected to aluminium conductors.
Install the thermostat onto an electrical box.
•
Install the thermostat about 5 ft. (1.5 m) high, on an inside wall facing the
•
heater.
Avoid locations where there are air drafts (such as the top of a staircase or
•
an air outlet), dead air spots (such as behind a door), or direct sunlight.
Do not install the thermostat on a wall that conceals chimney or stove
•
pipes.
The thermostat wires are not polarized; either wire can be connected to the
•
load or to the power supply.
ATTENTION: MERCURY RECYCLING NOTICE
This product does not contain mercury. However,
this product may replace a product that contains
mercury. Mercury and products containing mercury
should not be discarded in household trash.
For more information on how and where to properly
recycle a thermostat containing mercury in the
United States, please refer to the Thermostat
Recycling Corporation at
www.thermostat-recycle.org.
For mercury thermostat recycling in Canada, please
refer to Switch the Stat at www.switchthestat.ca
2