Tripp-Lite B013-HU-4K El Manual Del Propietario página 5

Installation
Notes:
• Prior to pulling cables through ceilings/walls, first test to ensure the entire
installation works properly.
• To achieve maximum distance and performance, use 24 AWG Solid-Wire UTP Cat6
cable (such as Tripp Lite N202-Series cable). Using stranded-wire Cat6 cable or
cable with a gauge (AWG) higher than 24 AWG will result in a shorter extension
distance. Higher gauge cabling (such as 26 AWG) has a more limited transmission
capability than lower gauge cabling.
PC
1. Make sure all equipment in the installation is powered off.
2. Using the included USB 2.0 A (M/M) cable, connect the PC USB port on
the transmitter to an available USB-A port on your source.
3. Using an HDMI cable (such as Tripp Lite's P569-XXX-CERT or
P568-XXX-2A Series cables), connect the transmitter's HDMI INPUT port
to an available HDMI port on your source.
4. (For bi-directional IR functionality - Optional) Connect the included
IR-IN or IR-OUT cable to the transmitter unit.
5. Using a user-supplied Cat5e (such as Tripp Lite N002-Series) or Cat6
(Tripp Lite N202-Series) cable, connect one end of the cable to the
HDBT OUT port on the transmitter unit. Below is a table of the maximum
distances that can be extended with Cat5e and Cat6 cables.
Category Cable
Cat5e
Cat6
6. Connect the other end of the Cat5e/Cat6 cable to the HDBT IN port on
the receiver unit.
7. Connect your keyboard and mouse to the USB ports labeled Keyboard/
Mouse on the receiver unit.
19-02-341-93395F.indb 5
Transmitter
HDMI
USB
Power
Keyboard / Mouse
Max Cable Length
115 ft. (35 m)
197 ft. (60 m)
130 ft. (40 m)
230 ft. (70 m)
Receiver
USB Power
Max Resolution Supported
4K x 2K @ 30 Hz
1920 x 1080 @ 60 Hz (1080p)
4K x 2K @ 30 Hz
1920 x 1080 @ 60 Hz (1080p)
5
HDMI Display
5/21/2019 11:34:16 AM