ResMed H5i Guia De Inicio Rapido página 2

B
1
3
5
Reassembling and filling the H5i water tub
Refer to illustration B.
Place the tub lid back onto the base.
1.
Clip all four side latches.
2.
Fill the water tub with distilled or deionized
3.
water up to the maximum water level mark.
4. Return the water tub to the H5i.
5. Close the flip lid ensuring that it clicks into
place.
For more information on the H5i, see your
2
Welcome and Information Guides. This
documentation is also available to download from
www.resmed.com on the Products page under
Service & Support.
WARNING
• Beware of electrocution. Do not immerse
your device or power cord in water. Always
unplug the device before cleaning and make
4
sure it is dry before plugging it back in.
• Take care when handling your H5i. The
water and the water tub base may both be
hot. Allow 10 minutes for the heater plate
and any excess water to cool.