Handling And Operation; Switching The Insoles On / Off / Selecting The Heat Setting - Crivit CEB 2000 A1 Instrucciones De Uso

♦ Plug the power adapter
that the battery packs
do not glow).
♦ Connect the connector plugs
the connection sockets
indicators
charged. The optimum charging time is a minimum of 6 hours
and a maximum of 8 hours.
♦ The battery packs
indicators
NOTE
► Frequent overcharging of the battery packs
8 hours) results in a reduction of both efficiency and
service lifetime.
► For longer storage periods (e.g. over the summer), the
battery packs
(charging time approx. 3 hours) to extend their service life.

Handling and operation

In this section you receive important information for the handling
and operation of the appliance.
Switching the insoles on / off /
selecting the heat setting
♦ Place the trimmed insoles
side down and run the cable upward along the heel.
♦ Attach the battery packs
connect the connector plug
nection sockets
Fig. 1
CEB 2000 A1
into a mains power socket. Ensure
are switched off (function indicators
of the battery packs
glow red and the battery packs
are fully charged when the function
glow green.
should be charged to half their capacity
in your shoes with the printed
using the straps to your shoes and
of the battery pack
of the power adapter
of the insoles
(see Figure 1).
GB │ IE
with
. The function
are being
(over
with the con-
│
25 ■