Correct Disposal Of This Product - Mastervolt Charge Mate Pro 40 Manual Del Usuario Y De Instalación

4
ENGLISH
Charge Mate Pro 40
The Mastervolt Charge Mate Pro 40 is a current limited electronic charge relay for the distribution of
charge current between two battery banks. The battery banks are connected when the voltage rises
above a pre-set value for at least 5 seconds. When the voltage drops the battery banks are isolated
again. With an optional remote control switch the Charge Mate Pro can be used as a switch for
emergency starts of the motor. This will overrule the automatic function and disables the current
limit.
Only use battery banks with the same type of charge characteristics.
The Charge Mate Pro can only be applied in 12 Vdc or 24 Vdc installations with a common
negative.
Safety regulations and measures
Install the Charge Mate Pro according to the instructions in this manual.
The Charge Mate Pro must be used in accordance with the specifications
Connections and safety features must be executed according to the locally applicable regulations.
Use cables with appropriate size wire and keep the cable connections as short as possible. Use
reliable terminals and fasten the bolts tightly, but do not over torque.
Examine your electrical installation on a regular base, at least once a year. Defects such as loose
connections, burnt wiring etc. must be corrected immediately.
Liability
Mastervolt cannot be held liable for:
Consequential damage resulting from the use of the Charge Mate Pro.
Possible errors in the included manual and the consequences of these.
Use that is inconsistent with the purpose of the product.
Warranty
Mastervolt assures the product warranty of the Charge Mate Pro during two years after purchase,
on the condition that the product is installed and used according to the instructions in this manual.
Installation or use not according to these instructions may result in under performance, damage or
failure of the product and may void this warranty. The warranty is limited to the cost of repair and/or
replacement of the product. Costs for labour or shipping are not covered by this warranty.

Correct disposal of this product

This product is designed and manufactured with high quality materials and
components, which can be recycled and reused. When this crossed-out wheeled bin
symbol is attached to a product, it means the product is covered by the European
Directive 2012/19/EU.
Please be informed about the local separate collection system for electrical and electronic products.
Please act according to your local rules and do not dispose of your old products with your normal
household waste. The correct disposal of your old product will help prevent potential negative
consequences to the environment and human health.
(Waste Electrical & Electronic Equipment)