Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Presure Filter
• The Pond Filter may require cleaning from time to time for
optimal performance.
• Before cleaning, always disconnect the pump from the
power source that is connected to the filter.
• Remove the filter pads and clean with water and when
they are visibly soiled.
• Return the filter pads with the fine filter pad (blue) in first,
and the coarse filter pad (black) on top.
NOTE: The bio-balls contain beneficial bacteria. At least
once a year the entire system should be disassembled and
cleaned thoroughly using warm water. This should not be
done during the warm season as it may take up to 8 weeks
to re-establish the environmental balance. The best time
of the year to "breakdown" your system is in early spring
before the water temperatures begin to rise. This is also the
ideal time to replace the filter pads.
• Filter pads should be replaced annually or when visibly
deteriorating. Use TotalPond
item #52232 (#RF13026) for a new fine and coarse filter
pad.
• Reconnecting the pump to the power source when you
are finished.
TROUBLESHOOTING
IF THE UV LIGHT FAILS TO OPERATE:
• Check to make sure the power cord is plugged in and the
light is getting power.
• Check to make sure that the lamp holder is screwed
completely into the body. (This product will not operate
unless it is fully assembled with the lamp holder screwed
completely into the body.)
• Check bulb to make sure that it has not burned out.
TotalPond
Replacement bulbs #52302 (#UVRB)
®
For more information on product maintenance
and maintenance videos, visit www.totalpond.
com
Replacement Filter Pads
®
7
Publicidad
Tabla de contenido
