Chapter 3 : Starting; Important - Black Box AC211A Manual Del Usuario

Chapter 3 : STARTING

Chapter 3 : STARTING
Turn OFF all of your equipment before connecting,
Connect the "VGA OUTPUT" of the "VIDEO to VGA converter" to the DATA INPUT of your Display device (Data
projector, Plasma screen,...).
Connect your video source (Camera, VCR...) to the "VIDEO to VGA converter" Video input "INPUT A:VIDEO"
(C.VIDEO or S.VIDEO or RGB/S).
Connect your VGA source (PC or Compatible) to the "INPUT B:PC" of the "VIDEO to VGA converter".
Select the Input (VIDEO (A) or PC (B)), and the Sync Type to deliver on "OUTPUT A/B" (STD or HV).
Turn On all of your input sources and your display device.
Connect the Power Supply and the AC main cable. The Power LED is now turned ON
THE COMPUTER OR VIDEO IMAGE MUST BE DISPLAYED INTO VGA
IMPORTANT: • If the VGA display is not clean, check if the "H.POS" potentiometer is timed at the middle
position (Rear Panel).
• In PAL/SECAM application check for a multisync. VGA Monitor (50Hz frame frequency), to
have a correct Aspect Ratio display.
PAGE 6
VIDEO to VGA converter