Philips SalonCurl Ceramic HP4658 Manual Del Usuario página 9

The green power-on light goes on. It stays on as long as the on/off slide is
set to 'I'.
After approximately 3 minutes the dot on the barrel changes colour
(becomes lighter). The appliance is now ready for use.
 Start styling when the colour of the dot has become light.
Prevent the brush from getting tangled in the hair in the following
,
way:
- Do not make the locks too thick.
- Do not wind a lock of hair more than twice round the brush.
- When unwinding a lock of hair, make sure that you hold the brush
away from the underlying hair.
5 Take a lock of hair and wind it round the brush. Make sure the end
of the lock is wound in the required direction. (Fig. 11)
6 Keep the brush in your hair for approximately 15 seconds. (Fig. 1)
7 Remove the brush from the hair by unwinding the lock of hair.
(Fig. 1)
cleaning
Always switch the appliance off, unplug it, put it in a safe place and let it
cool down.
Never rinse the appliance with water.
1 Clean the appliance with a small brush or a dry cloth.
HP658 only:
,
 Remove the slide-on brush from the appliance before cleaning it.
 Clean the slide-on brush with a moist cloth.
 Dry the slide-on brush before using or storing it.
storage
Always switch the appliance off, unplug it and let it cool down before
storing it.
EnglisH
9