Engineer Programming Mode; To Enter Programming Mode; Changing Supervisor Codes; Adding User - PRASTEL Fingerkey Manual Del Usuario

Power Up
After all wiring is complete and the unit face plate is attached
to the back plate, apply 12Vdc power to the unit. Power LED
illuminated and accept LED flashing.

Engineer Programming Mode

To enter programming mode

Press: * Supervisor code #
GB
Note
The Supervisor code is 9999 at factory default setting.

Changing Supervisor Codes

In engineer programming mode:
To change Supervisor code
Press: 0 new supervisor code # re-enter new
supervisor code #
Note
The supervisor code must be 4-digit number.

Adding User

Up to 2 fingerprints can be programmed for each user
Press: 1 user ID # fingerprints 1 fingerprints 2 #
Note
The user ID must be 1 - 3 digit number within 1-800.
To Add Multi-user
Adding more than 1 user
- 25 -