Dome cover fixing screw (with washer, 1 pc.)
Installation auxiliary wire
Washer
Enclosure
Specifications
Ambient operating temperature:
Mass:
Dimensions:
Standard Accessories
Operating Instructions (this document) .............1 set
Waterproof rubber (for replacement) ................1 pc.
ClearSight coating label ...................................1 pc.
Precautions
• Due to effectiveness of the rain wash coating, drops are likely to be accumulated right under
the camera and it may cause a partial distortion of the video.
• When cleaning the dome cover, hose or spray fresh water that is not containing lubricant agent
or silicon substances and wash away adherents such as grain of sand. If dirt is hard to remove,
use a sponge soaked into the fresh water mentioned above and wipe off.
• Do not wipe the cover with a dry cloth. (Using dry cloth may spread oil constituent adhered to
the surface, and it may result in damaging the rain wash coating.)
• If dirt cannot be wiped off with a damp cloth, use a neutral detergent and sufficiently rinse off
the detergent.
• Do not use organic solvent such as benzine and thinner.
• Before using a spray, abandon a few sprays to eliminate impurities.
• The mark of light-shielding parts left inside the dome or dirt on the dorm cover may influence
the reflection of infrared rays.
Therefore, remove those marks and dirt using cleaning paper.
* Improper cleaning of the dome cover may cause the rain wash coating to become less effective.
In this case, in order to have effective rain wash coating, a new dome cover must be purchased
to replace the existing dome cover. Consult with your dealer or construction contractor.
4
Dome cover fixing screws
(without washer, 2 pcs.)
Protrusion
–45 °C to +60 °C {–49 °F to 140 °F}
Approx. 74 g {0.16 lbs}
Diameter: 115 mm {4-17/32 inches}
Height: 60 mm {2-3/8 inches}
Dome radius 42 mm {1-21/32 inches}
Dome cover holding plate
Dome cover
Waterproof rubber