Hanging The Fan - HAMPTON BAY Bryant Manual Del Propietário

Hanging the Fan

REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
1. Secure the mounting bracket to the
ceiling outlet box with the screws and
washers provided with your outlet box.
(Figure 5)
2. Loosen the two set screws from the
motor assembly. (Figure 6)
3. Remove hanger ball from downrod assembly
by loosening set screw, removing the cross pin,
and sliding ball off rod. Remove the hitch pin
and lock pin from the downrod assembly.
(Figure 7)
4. Carefully feed fan wires up through the
downrod. (Figure 8) Thread the rod into the
coupling. Next, line up holes and replace lock
pin and hitch pin. Tighten set screws.
5. Slip coupling cover, canopy cover and
canopy onto downrod. (Figure 9) Carefully
reinstall hanger ball onto downrod, make sure
that cross pin is in correct position, set screws
are tighten and wires are not twisted.
6. Now lift motor assembly into position and place
hanger ball into mounting bracket. Rotate until the
check groove drops into the registration slot and
seats firmly. (Figure 10) Downrod
if this is done correctly.
Outlet box
Mounting bracket
Figure 5 Figure 6
Cross pin
Hanger
ball
Downrod
Hitch
pin
Lock
Figure 7 pin Figure 8
should not rotate
Set
screws
Figure 9
Downrod
Supply
wires
Figure 10
Lead Wires
Ball/Downrod
Assembly
Canopy cover
Hitch
pin
Registration
slot
Canopy
Coupling
Cover
Lock
pin
Motor Collar
4